D-630 Flash Dryer 110 or 220 volts

The safest and best flash dryer in the industry. The base is heavy steel to prevent tipping at 600 degrees. Also, the base is designed to be under the platen to avoid a tripping hazard like those flash dryers with legs sticking out. The base is on casters which will allow the dryer to roll, if bumped into. The poles telescope to adjust height, and the manual flash dryers can be upgraded later to an automated unit by replacing one of the poles. The heater control is solid state. Control is essential, because different fabrics can tolerate different amounts of heat, and different inks have different curing requirements. The heater should be 1.5-2" above the garment for the heat to be evenly distributed across the printed image. Flash dryers without heat control will scorch the garment before they cure the ink. Our heat control does not have a relay that turns the heat on and off while you are curing like dryers sold by other companies. This flash is simply the best technology in the industry.